Submissions

Online Submissions

Already have a Username/Password for SINGULARITY: Jurnal Desain dan Industri Kreatif?
Go to Login

Need a Username/Password?
Go to Registration

Registration and login are required to submit items online and to check the status of current submissions.

 

Author Guidelines

General provisions in writing SINGULARITY: Jurnal Desain dan Industri Kreatif manuscript are as follows:

  1. The manuscript is written in good Indonesian ;
  2. The manuscript should be written with correct spelling, sentences, and paragraph arrangements corresponding to the grammar used;
  3. The manuscript should be written with A4 (210 x 297 mm) page size and with a left margin of 25 mm, a right margin of 20 mm, a lower margin of 20 mm, and a top margin of 30 mm;
  4. For manuscript format conformity, the author(s) must use our journal template.
  5. If the manuscript is written in Indonesian, use the Indonesian equivalent of words for foreign words or terms. If not found, the foreign term is written in italic.
  6. The chapters in the manuscript (Introduction, Research Methodology, Results and Discussions, and Conclusion) should be numbered in sequential Roman numeric format starting from number one. The chapter's title is written in bold with the Title Case format and arranged centered with no underscores.
  7. Images and tables are placed so that the position is on the top of the page;
  8. Each image must be clear (font size, resolution, and line size must be clearly printed);
  9. Each image must be given a caption (bottom caption) at the bottom of the drawing and serial numbered Arabic numerals followed by the title of the image, for example, as shown in Figure 1;
  10. Each table should be labeled ( table caption ) and serial numbered Arabic numerals at the top of the table followed by a table title, for example, as shown in Table 1;
  11. Tables contain vertical lines, whereas horizontal lines are only given in the table heading and at the table's bottom.
  12. Figures and tables and diagrams/schematics should be placed according to columns between text groups, or if they are too large, they can be placed in the middle of the page (one column);
  13. Each equation should be written using the Equation Editor in MS Word or Open Office. Equations are not allowed to be embedded in the manuscript as images;
  14. The manuscripts shall conform with proper SI usage (International System of Units) and the basic principles concerning quantities and units;
  15. References or citations are using the APA Style 6.0  format (numbering).  Citing a reference can be written using numbering surrounded by square brackets, for example [1]. Citing more than one reference can be written with separate square brackets, for example, [2], [4], [5], [7]-[9].
  16. Citing reference using author name can be written using the author's last name and mentioning the reference number, for example, as stated in Widianto [2], Widianto and Rochim [3] and by Widianto et al. [4];
  17. Management reference application, such as MendeleyZotero, or Endnote, should be used by authors when citing a reference and creating the bibliography in the manuscript;

 Specific Instructions

The manuscripts must be composed of the following scientific article components (subtitles-in order), as follows:

  1. Article Title: Identify the main issue of the article. Begin with the subject of the article. The title should be accurate, unambiguous, specific, and complete. Do not contain infrequently-used abbreviations.
  2. Authors Name and Affiliations: Write Author(s) names without a title and professional positions such as Prof, Dr, Production Manager, etc. Do not abbreviate your last/family name. Always give your First and Last names. Write clear affiliation of all Authors. Affiliation includes the name of department/unit (or faculty), the university's name or institution, address, country. Please indicate Corresponding Author (include email address) by adding an asterisk (*) in superscript behind the name.
  3. Abstract and Keywords: An abstract should stand alone, which means that no citation in the abstract. Consider it the advertisement for your article. The abstract should tell the prospective reader what you did and highlight the key findings. Avoid using technical jargon and uncommon abbreviations. You must be accurate, brief, clear, and specific. Use words that reflect the precise meaning. The abstract should be precise and honest. Please follow the word limitations (100‐200 words). Keywords are the labels of your manuscript and critical to correct indexing and searching. Therefore the keywords should represent the content and highlight of your article. Use only those abbreviations that are firmly established in the field. Each keyword is separated by a semicolon (;).
  4. Introduction: In the Introduction, the Authors should state the work's objectives at the end of the introduction section. Before the objective, the Authors should provide an adequate background and concise literature survey to record the existing solutions/method, to show which is the best of previous research, to show the main limitation of the previous research, to show what do you hope to achieve (to solve the limitation) and to show the scientific merit or novelties of the paper. Avoid a detailed literature survey or a summary of the results. Do not describe the literature survey as author by author, but should be presented as the group per method or topic reviewed, which refers to some literature. Example of novelty statement or the gap analysis statement at the end of the Introduction section (after the state of the art of previous research survey): “........ (short summary of background)....... A few researchers focused on ....... There have been limited studies concerned on ........ Therefore, this research intends to ................. The objectives of this research are .........”.
  5. Research Methods: The research method describes the stages of research/development undertaken to achieve the research's objectives/outputs.  Each stage is briefly described (e.g., each step in a paragraph). Also, inform the materials/platforms used in the study, including the subjects/materials, the tools/software used, the design or experiment used, the sampling technique, the test plan (the variable to be measured and the data retrieval technique), analysis and statistical model used.
  6. Results and Discussion: Results should be clear and concise. The results should summarize (scientific) findings rather than providing data in great detail. Please highlight the differences between your results or findings and the previous publications by other researchers. The discussion should explore the significance of the results of the work, not repeat them. Combined results and their discussion paragraph is often appropriate. Avoid extensive citations and discussion of published literature. In the discussion, it is the most important section of your article. Here you get the chance to sell your data. Make the discussion corresponding to the results, but do not reiterate the results. Often should begin with a brief summary of the main scientific findings (not experimental results). The following components should be covered in the discussion: How do your results relate to the original question or objectives outlined in the Introduction section (what/how)? Do you provide interpretation scientifically for each of your results or findings presented (why)? Are your results consistent with what other investigators have reported (what else)? Or are there any differences?
  7. Conclusion: The conclusion should answer the objectives of the research. Tells how your work advances the field from the present state of knowledge. Without clear Conclusions, reviewers and readers will find it difficult to judge the work and whether it merits publication in the journal. Do not repeat the Abstract or list experimental results. Provide a clear scientific justification for your work, and indicate possible applications and extensions. It would help if you also suggested future experiments and/or point out those that are underway.
  8. References: All references referred to in the article text must be listed in the References section. The references shall contain at least 15 (fifteen) references from primary sources (scientific journals, conference proceedings, research reference books) or 80 % of total references, which are published within 5 (five) years.  The citation format and the references must follow the APA 6.0 Style format.

[1]           Authors Last Name, Initial(s). (year). Book Title. Edition. Place: Publisher. ← Book

[2]           Engelmore, R., Morgan, A. (1986). Blackboard Systems. Edition. Reading, Mass.: Addison-Wesley. ← Book

[3]           Authors Last Name, Initial(s). (year). Article Title. Journal Title. Volume (Issue Number: optional), page number start-page number end. DOI information. ← Journal

[4]           Robinson, A.L. (1980). New Ways to Make Microcircuits Smaller. Science, 208, 1019-1026. DOI: 10.1126/science.208.4447.1019. ← Journal

[5]           Bhavsar, D.S., Saraf, K.B. (2002). Morphology of PbI2 Crystals Grown by Gel Method. Crystal Research and Technology, 37, 51–55. DOI: 10.1002/1521-4079(200202)37:1%3C51::AID-CRAT51%3E3.0.CO;2-N ←Journal

[6]           Li, M., Xing, S., Yang, L., Fu, J., Lv, P., Wang, Z., Yuan, Z. (2019). Nickel-loaded ZSM-5 catalyzed hydrogenation of oleic acid: The game between acid sites and metal centers. Applied Catalysis A: General. 587, 117112. DOI: 10.1016/j.apcata.2019.117112. ←Journal

[7]           Clancey, W.J. (1983). Communication, Simulation, and Intelligent Agents: Implications of Personal Intelligent Machines for Medical Education. In Proceedings of the Eighth International Joint Conference on Artificial Intelligence, 556-560. Menlo Park, Calif.: International Joint Conferences on Artificial Intelligence, Inc. ←Conferences

[8]           Amin, N.A.S., Istadi, I. (2012). Different Tools on Multiobjective Optimization of a Hybrid Artificial Neural Network – Genetic Algorithm for Plasma Chemical Reactor Modelling. In Olympia Roeva (Editor) Real-World Applications of Genetic Algorithms. Croatia: InTech Publisher. ← Book Chapter

[9]           Rice, J. (1986). Polygon: A System for Parallel Problem Solving, Technical Report, KSL-86-19, Dept. of Computer Science, Stanford Univ. ←Report

[10]        Clancey, W.J. (1979). Transfer of Rule-Based Expertise through a Tutorial Dialogue. Ph.D. Dissertation, Department of Computer Science, Stanford University. ←Thesis

[11]        Ivey, K.C. (2 September 1996). Citing Internet sources URL http://www.eei- alex.com/eye/utw/96aug.html. ←Website (but should be avoided)

 

Submission Preparation Checklist

As part of the submission process, authors are required to check off their submission's compliance with all of the following items, and submissions may be returned to authors that do not adhere to these guidelines.

  1. The submission article has not been previously published, nor is it before another journal for consideration (or an explanation has been provided in Comments to the Editor)

  2. The submission file is in Microsoft Word document file format. The maximum file size is 2 MB
  3. The submission article must follow journal guidelines. See the Journal Template and Author Guidelines
  4. Where available, URLs for the references have been provided.
  5. The text uses a single space; 12 point font; use italics, not underscores (except with URL addresses); and all illustrations, figures, and tables are placed in the text at the correct point.
  6. If submitting to a peer-reviewed section of the journal, the instructions in Ensuring a Blind Review have been followed.
     
 

Copyright Notice

The author(s) whose article is published in the SINGULARITY: Jurnal Desain dan Industri Kreatif attain the copyright for their article. By submitting the manuscript to the journal, the author(s) agree with this policy. No special document approval is required.

The author(s) guarantee that their article is original, written by the mentioned author(s), has never been published before, does not contain statements that violate the law, does not violate the rights of others, is subject to copyright that is held exclusively by the author(s), and is free from the rights of third parties, and that the necessary written permission to quote from other sources has been obtained by the author(s).

The author(s) retain all rights to the published work, such as (but not limited to) the following rights:

Copyright and other proprietary rights related to articles, such as patents, The right to use the substance of the article in its own future works, including lectures and books, The right to reproduce articles for its own purposes, The right to archive articles yourself, and The right to enter into separate additional contractual arrangements for the non-exclusive distribution of published versions of articles (for example, posting them to institutional repositories or publishing them in a book), with acknowledgment of its initial publication in this journal.

If the article was prepared jointly by more than one author, each author submitting the manuscript warrants that they have been given permission by all co-authors to agree to copyright and license notices (agreements) on their behalf, and agree to notify the co-authors of the terms of this policy. We will not be held responsible for anything that may arise because of the writer's internal dispute. SINGULARITY: Jurnal Desain dan Industri Kreatif will only communicate with correspondence authors.

Authors should also understand that once published, their articles (and any additional files, including data sets, and analysis/computation data) will become publicly available. The license of published articles (and additional data) will be governed by the Creative Commons Attribution license as currently featured on the Creative Commons Attribution-ShareAlike 4.0. We allow users to copy, distribute, display and perform work under license.

Users need to attribute the author(s) and SINGULARITY: Jurnal Desain dan Industri Kreatif to distribute works in journals and other publication media. Unless otherwise stated, the author(s) is a public entity as soon as the article is published

 

Privacy Statement

The names and email addresses entered in this journal site will be used exclusively for the stated purposes of this journal and will not be made available for any other purpose or to any other party.